An LVDT is used to measure displacement. The LVDT feeds a Voltmeter of – InterviewSolution

InterviewSolution

1.	An LVDT is used to measure displacement. The LVDT feeds a Voltmeter of 0-5 V range through a 250 gain amplifier. For a displacement 0.5 mm the output of LVDT is 2 mV. The sensitivity of instrument is
Answer» Final output = 2 x 10-3 x 250 = 0.5 V. .

Discussion

No Comment Found

Related InterviewSolutions

A 1 mA meter is to be converted to 1 A ammeter. The meter resistance is 100 &ohm;. The value of shunt resistance is
The use of thermocouple meters for ac measurement leads to a scale which is
The current in a circuit is measured using a 150 : 1 CT If the ammeter reads 0.6 A, the circuit current is
A volt ratio box should have low resistance.
A Hall effect transducer has K = - 1 x 10. If B = 1 Wb/m, I = 3 A and bismuth slab is 2 mm wide, the Hall voltage is
Two ammeters A and B both 0-10 A have internal resistance of 1 &ohm; and 0.5 &ohm; respectively. They are connected in parallel. If total current is 15 A, then
A meter having 0-1000 μA range and 1000 &ohm; resistance is required to be changed to 0-100 mA meter. The value of shunt resistance is about
An induction wattmeter can be used for
In the balanced bridge shown in figure. should be
If the current in a capacitor leads the voltage by 80°, the loss angle of capacitor is