Assertion : In transistor common emitter mode as an amplifier is prefered over common base mode. Reason: In common emitter mode the input signal is connected in series with the voltage applied to the base emitter function.A. If both the assertion and reason are true and reason is a true explantion of the assertion.B. If both the assertion and reason are true but the reason is not true the correct explantion of the assertion.C. If the assertion is true but reason falseD. If both the assertion and reason are false.

Assertion : In transistor common emitter mode as an amplifier is prefe

1.	Assertion : In transistor common emitter mode as an amplifier is prefered over common base mode. Reason: In common emitter mode the input signal is connected in series with the voltage applied to the base emitter function.A. If both the assertion and reason are true and reason is a true explantion of the assertion.B. If both the assertion and reason are true but the reason is not true the correct explantion of the assertion.C. If the assertion is true but reason falseD. If both the assertion and reason are false.
Answer» Correct Answer - B Common emitter is prepared over common base because all the current, voltage and power gain of common emitter amplifier is much more than the gains of common base amplifier.

Discussion

No Comment Found

Related InterviewSolutions

The depletion layer in diode is `1 mum` wide and the knee potential is `0.6 V`, then the electric field in the depletion layer will beA. zeroB. `0.6 Vm^(-1)`C. `6xx10^(4) V//m`D. `6xx10^(5)V//m`
The diagram shows an operational circuit. Which of the following correctely states the nature and magnitude of the amplification ? A. `{:("Nature","Magnitude of"(V_(0))/(V_(i))),("Inverting"," 0.2"):}`B. `{:("Nature","Magnitude of"(V_(0))/(V_(i))),("Inverting"," 5.0"):}`C. `{:("Nature","Magnitude of"(V_(0))/(V_(i))),("Non-inverting"," 0.2"):}`D. `{:("Nature","Magnitude of"(V_(0))/(V_(i))),("Non-inverting"," 5.0"):}`
The following truth table corresponds to the logic gate `|(A,0,0,1,1),(B,0,1,0,1),(X,0,1,1,1)|`A. `NAND`B. `OR`C. `AND`D. `XOR`
Which of the following gates corresponds to the truth table given below ? `|(A,B,X),(1,1,0),(1,0,1),(0,1,1),(0,0,1)|`A. `XOR`B. `OR`C. `NAND`D. `NOR`
The following truth table belongs to which one of the following four gates? `|(A,B,C),(1,1,0),(1,0,0),(0,1,0),(0,0,1)|`A. `OR`B. `NAND`C. `XOR`D. `NOR`
Pure sodium `(Na)` is a good conductor of electricity because the `3s` and `3p` atomic bands overlap to from a partially filled conduction band. By contrast the ionic sodium chloride `(NaCl)` crystal isA. InsulatorB. ConductorC. SemiconductorD. None of these
In an insulator, the forbidden energy gap between the valence band and conduction band is of the order ofA. `1 MeV`B. `0.1 MeV`C. `1 eV`D. `5 eV`
In a good conductor the energy gap between the conduction band and the valence band isA. InfiniteB. WideC. NarrowD. Zero
In a common emitter amplifier , when a signal of 40 mV is added to the input voltage, the base current changes by `100 muA` and emitter current changes by 2.1mA the trans-conductance isA. `1/20 Omega^(-1)`B. `1/50 Omega^(-1)`C. `50 Omega^(-1)`D. `15 Omega^(-1)`
In the given circuit, calculate the ratio of currents through the battery if (1) Key `K_(1)` is pressed, `K_(2)` open and then (2) Key `K_(2)` is pressed, key `K_(1)` is opened A. `1/2`B. 4C. 2D. 1

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment