Crude oil is in the form of ____________(a) emulsion of oil and brine(b) emulsion of oil and impurities(c) emulsion of brine and impurities(d) emulsion of impurities and moistureI got this question in unit test.Query is from Mining of Petroleum topic in section Fuel Technologies of Applied Chemistry

Crude oil is in the form of ____________(a) emulsion of oil and brine(

1.	Crude oil is in the form of ____________(a) emulsion of oil and brine(b) emulsion of oil and impurities(c) emulsion of brine and impurities(d) emulsion of impurities and moistureI got this question in unit test.Query is from Mining of Petroleum topic in section Fuel Technologies of Applied Chemistry
Answer» Correct choice is (a) emulsion of oil and brine The BEST I can explain: The crude oil is obtained from the EARTH’s crust which will be in the form of emulsion of oil and brine. It is very STABLE. When this emulsion is CHARGED then water GETS separated from the oil.

Discussion

No Comment Found

Related InterviewSolutions

The pressure applied in vapour phase cracking is __________(a) 10-20kg/cm^2(b) 100kg/cm^2(c) 50kg/cm^2(d) 80kg/cm^2This question was addressed to me in an interview for internship.Question is taken from Cracking and Knocking of Petroleum topic in section Fuel Technologies of Applied Chemistry
Knocking is also called as __________(a) cracking(b) pinging(c) doping(d) crushingI got this question in a job interview.The question is from Cracking and Knocking of Petroleum topic in section Fuel Technologies of Applied Chemistry
What is the catalyst used in catalytic polymerization?(a) Phosphoric acid(b) Al2O3(c) Al2(siO3)3(d) Zirconium oxideThe question was posed to me in an interview.My question comes from Mining of Petroleum in division Fuel Technologies of Applied Chemistry
Naphthenes having more than 20 C-atoms are called as ________(a) cyclo alkenes(b) cyclo alkanes(c) cyclo paraffins(d) cyclo alkynesThe question was posed to me in an international level competition.Question is taken from Classification of Crude Oil based on their Composition topic in portion Fuel Technologies of Applied Chemistry
The flame colour of the aromatic compounds is ________(a) yellow(b) orange(c) green(d) pinkThe question was posed to me during an online exam.I need to ask this question from Classification of Crude Oil based on their Composition topic in division Fuel Technologies of Applied Chemistry
The moisture content in the coal can be given by heating the coal for _____ hours.(a) 2(b) 1(c) 4(d) 6I had been asked this question in homework.I'd like to ask this question from Analysis of Coal and Selection in portion Fuel Technologies of Applied Chemistry
The moisture content of the good fuel must be _________(a) 50%(b) High in amount(c) Low in amount(d) 70%I got this question in an internship interview.My query is from Characteristics of Good Fuel and its Advantages topic in division Fuel Technologies of Applied Chemistry
Which of the following is not the constitute of CNG?(a) Ethane(b) Propane(c) Isobutane(d) COI have been asked this question in my homework.My doubt stems from Fuel Technologies Problems topic in portion Fuel Technologies of Applied Chemistry
Power alcohols contains ________(a) 50-60% of petrol(b) 70-80% of petrol(c) 50-60% of ethanol(d) 70-80% of ethanolI had been asked this question at a job interview.Query is from Power alcohols as Fuels topic in section Fuel Technologies of Applied Chemistry
The gasoline vapours are purified by __________(a) thermal cracking(b) catalytic cracking(c) stabilization(d) knockingThe question was posed to me in exam.My question is taken from Cracking and Knocking of Petroleum topic in division Fuel Technologies of Applied Chemistry

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment