Explain Does Ha Declare Or Determines That Master Esxi Has Isolated?

1.	Explain Does Ha Declare Or Determines That Master Esxi Has Isolated?
Answer» In the CASE of the isolation of a master, this timeline is a bit less complicated because there is no need to GO through an election process. In this timeline, “s” refers to seconds. T0 – Isolation of the host (master). T0 – Master pings “isolation ADDRESSES”. T5s – Master declares itself ISOLATED and “TRIGGERS” isolation response. In the case of the isolation of a master, this timeline is a bit less complicated because there is no need to go through an election process. In this timeline, “s” refers to seconds.

Answer»

In the CASE of the isolation of a master, this timeline is a bit less complicated because there is no need to GO through an election process. In this timeline, “s” refers to seconds.

T0 – Isolation of the host (master).
T0 – Master pings “isolation ADDRESSES”.
T5s – Master declares itself ISOLATED and “TRIGGERS” isolation response.

In the case of the isolation of a master, this timeline is a bit less complicated because there is no need to go through an election process. In this timeline, “s” refers to seconds.

Discussion

No Comment Found

Related InterviewSolutions

Does Ha Seeks Assistance From Drs Before Starting Failover Of Failed Vm’s?
If A Slave Esxi Has Been Removed From A Cluster Then Will Election Be Triggered Again?
Will Master Election Happen If A New Esxi That Has Visibility To More Datastores Than Existing Master Is Introduced In A Cluster?
What Will Happen If A Vm Fails When Svmotion Was Going On That Vm And Has Not Been Completed Yet? How This Failure Will Be Handled By Ha?
What Are The Things Which Ha Take Into Account Before Restarting Vm’s?
What Will Happen When Election Of Master Is Going On In A Cluster And At The Same Time One Of The Slaves Esxi Host Also Failed? How This Failure Will Be Handled Since At The Time Of Failure There Is No Master Esxi Host?
What Are The Cases When Election Of Master Takes Place In A Cluster?
Which Parameter Need To Configure To Increase The Response Time For Isolation Detection?
How Does Ha Keep Track Of Which Vm Are Needed To Be Restart In Case Of An Esxi Host Failure?
How Does Ha Determines Which Vm’s It Need To Restart Which Were Powered Off Or Shutdown Due To Triggered Isolation Response?

Explain Does Ha Declare Or Determines That Master Esxi Has Isolated?

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment