Netware Workstation Installation :

Non-Dedicated w/s :

It is w/s same as stand-alone machine. This w/s consist of its own HDD & it is partially depend on Server Procedure :

1. Reboot the system from A drive. Min DOS version MUST be COMPATIBLE with Netware with this command.com is loaded by w/s.
2. INSERT w/s installation disk in drive & type A:> IPX.COM. When IPX is loaded it will configure address for the w/s.
3. Type A:>NETX.COM with which latest version of Netware is loaded by w/s with the server if version at Netware w/s matches with the server it displays F prompt.

Dedicated Workstation :

These are diskless w/s, which are totally DEPENDANT on server for booting process. Procedure :

1. Insert Boot ROM Chip into the NIC of w/s.
2. Switch on w/s with this NET$DOS.SYS file gets executed from w/s. It also called as Netware Shell. It acts as interface between DOS & Netware. NOTHING but it intersects DOS with Netware. Whenever commands are related with DOS then these commands are executed from w/s & if commands are related with Netware, it executed under Netware Environment. This file is basically used to distinguish between DOS & Netware e.g. Setpass executed from w/s & Attached directed to the Server.

Netware Workstation Installation :

Non-Dedicated w/s :

It is w/s same as stand-alone machine. This w/s consist of its own HDD & it is partially depend on Server Procedure :

Dedicated Workstation :

These are diskless w/s, which are totally dependant on server for booting process. Procedure :