Explain the Crimping process to make Ethernet cables?

1.	Explain the Crimping process to make Ethernet cables?
Answer» Crimping process for making Ethernet cables 1. Cut the cable with desired length 2. Strip the insulation sheath about 1 inch from both end of the cable and expose the Twisted pair wires 3. After stripping the wire, untwist the smaller wires and arrange them into the proper wiring scheme, T568B preferred generally. 4. Bring the wires tighter together and cut them down so that they all have the same length ( Vi inch). 5. Insert the all 8 coloured wires into the eight grooves in the connector. The wires should be, inserted until the plastic sheath is also inside the connector. 6. Use the crimping tool to lock the RJ45 connector on the cable. It should be strong enough to handle manual traction. Now it is ready for data transmission. 7. Use a cable tester to verify the proper connectivity of the cable, if need.

Answer»

Crimping process for making Ethernet cables

1. Cut the cable with desired length

2. Strip the insulation sheath about 1 inch from both end of the cable and expose the Twisted pair wires

3. After stripping the wire, untwist the smaller wires and arrange them into the proper wiring scheme, T568B preferred generally.

4. Bring the wires tighter together and cut them down so that they all have the same length ( Vi inch).

5. Insert the all 8 coloured wires into the eight grooves in the connector. The wires should be, inserted until the plastic sheath is also inside the connector.

6. Use the crimping tool to lock the RJ45 connector on the cable. It should be strong enough to handle manual traction. Now it is ready for data transmission.

7. Use a cable tester to verify the proper connectivity of the cable, if need.

Discussion

No Comment Found

Related InterviewSolutions

The IEEE standard was first published in(a) 1983(b) 1984(c) 1985(d) 1986
PARC stands for ………
How many types of wiring techniques to construct the ethernet cable?(a) 2(b) 3(c) 4(d) 5
……….. is the most popular Ethernet cable
What is the another name of patch cable?(a) RJ45(b) crimping(c) Twisted pair(d) LAN cable
Wireless Ethernet cards uses …… waves to transmit data.(a) radio(b) micro(c) UV(d) Infrared
Fill in the blanks.1. ……… is the process of joining two or more pieces of metal or wire by deforming one or both of them to hold each other2. The ……. tool is used to connect the patch wire and the Ethernet connector.
What is RJ?
Match the following(i) Straight-through wiring – 1. 1 to 1, 2 to 2, 3 to 3(ii) Cross-over wiring – 2. 1 to 3, 3 to 1, 6 to 2 (iii) Roll-over wiring – 3. 1 to 8, 2 to 7, 3 to 6 (a) (i)-1 (ii)-2 (iii)-3(b) (i)-3 (ii)-2 (iii)-1(c) (i)-2 (ii)-1 (iii)-3(d) (i)-1 (ii)-3 (iii)-2
……… are used for PC to PC networking.(a) Serial interface cables b) Fibre optic cables(c) Parallel Interface cables(d) a and c