To configure a Many-to-One NAT policy that allows all computers on the X1 interface to initiate traffic using the SonicWALL SECURITY appliance’s WAN IP ADDRESS,

we need to perform the following steps:

1. Navigate to Network > NAT Policies PAGE and Click on Add. Then Add NAT Policy dialog box is displayed.
2. For Original Source, select the option Any.
3. For Translated Source, we need to select WAN Interface IP.
4. For Original Destination, we need to select Any.
5. For the Translated Destinations, we need to select Original.
6. For Original Service, we need to select Any.
7. For Translated Service, we need to select Original.
8. For Inbound Interface, we need to select X1.
9. For Outbound Interface, we need to select X1.
10. In COMMENT, we need to enter a short description.
11. Followed by clicking on the Enable NAT Policy checkbox.
12. We need to Leave Create a reflexive policy unchecked.
13. Finally Click Add.

To configure a Many-to-One NAT policy that allows all computers on the X1 interface to initiate traffic using the SonicWALL security appliance’s WAN IP address,

we need to perform the following steps: