In a single phase full bridge converter (B - 2 connection), the input – InterviewSolution

InterviewSolution

1.	In a single phase full bridge converter (B - 2 connection), the input voltage is = V sin ω. The output dc voltage for resistive load
Answer» SCRs conduct from a to p in each half cycle.

Discussion

No Comment Found

Related InterviewSolutions

In a dual converter both converters work as rectifiers.
A single phase full wave regulator feeds R-L load. The best gating signal is
A 3 phase induction motor is fed by a 3 phase ac regulator to change the stator voltage. The variation in speed will be more if
A cycloconverter cannot give a frequency higher than input frequency.
A dc circuit breaker must use
In a single phase full wave regulator feeding R-L load, the minimum firing angle can be zero.
An RC snubber circuit is used to protect a thyristor against :
UJT can be used for
In a series inverter supplying a load resistance R, the commutating elements L and C should be such that
In a full wave converter (M - 2 connection) feeding an RLE load, the peak thyristor current is 15 A. For fully controlled bridge circuit and same load current, the peak thyristor current will be