InterviewSolution
Saved Bookmarks
InterviewSolution
| 1. |
Solve : Computer turns on for ~1 second, then immediately off.? |
|
Answer» I just transferred my computer components to a new case, it had previously been WORKING fine. 3 beeps - Base 64 K memory failure This made me think that maybe my MOBO wasn't screwed, so I tried each of the 2 RAM STICKS individually, and it shut down as before. Then I tried known good RAM from ANOTHER computer, still nothing. I also tested the MOBO battery with a multimeter, and it was good. So unless someone knows anything else I could try, then I suppose I need to buy a new Motherboard.If it were in my hands and assuming that all of the components are off the MB apart from a stick of RAM, I'd be connecting a POST tester. Without that, I'd maybe disconnect all power to the PC, pull the CMOS battery and leave it out for around 15mins then reinsert battery and power up again. If that doesnt work, take the MB out of the case, connect the power from the PSU to the board along with the cpu fan and without using the 'power-on' switch, momentarily bridge the power switch terminals on the MB and see if it runs. That way you've bypassed everything associated with the case internals. Something I've found in the past is some of the case lights and switches can be wired incorrectly from assembly.Quote from: Sodde on May 26, 2010, 05:55:23 PM .... Yes, the front panel is not wire right.Make sure the cpu cooler is on properly and thermal PASTE is properly installed. It is possible the cooler came loose with the move and the cpu is SHUTTING it down from the heat?Quote from: hejlik on May 27, 2010, 10:40:45 AM Make sure the cpu cooler is on properly and thermal paste is properly installed. It is possible the cooler came loose with the move and the cpu is shutting it down from the heat? I doubt it, not in ~1 second. I did some experiments with this and the fastest I could get it to shut back down was nearly 10 seconds. Joonce, double and triple check your connection, including the front case wiring and all power cables. If you have to, take it apart and put it back together, taking the time to clean out the memory slots and checking that all of the connectors are undamaged, clear of any obstructions, and properly and firmly connected. It is entirely possible that the board got damaged when you moved it, through a static shock or something.Did you test the mobo on the bench? if not, try that. Take out the mobo along with the CPU, RAM, video card if yiu have it separate and the PSU and power it up out of the case. Place it on some book or a cardboard box (the mobo box is fine). It's possible that something inside the case is causing a short, causing the mobo to power off. Use a POST card if you still can't power it on, as suggested by others.double check all wiring and make sure all obstructions on the plating are cleared it is possible that the wiring could be affected by static or something let me know if its not fixed |
|