Technician A Says The Closed Coil End Of A Valve Spring Should Go Aga

1.	Technician A Says The Closed Coil End Of A Valve Spring Should Go Against The Cylinder Head. Technician B Says All Valve Springs Use Shims To Control Free Spring Height. Who Is Right?
Answer» Technician A is a correct. A CLOSED coil END of a valve spring should go against the cylinder head. Technician B is wrong because all valve SPRINGS do not use SHIMS to control assembled height. It is also wrong because it should STATE assembled height. Technician A is a correct. A closed coil end of a valve spring should go against the cylinder head. Technician B is wrong because all valve springs do not use shims to control assembled height. It is also wrong because it should state assembled height.

Technician A Says The Closed Coil End Of A Valve Spring Should Go Against The Cylinder Head. Technician B Says All Valve Springs Use Shims To Control Free Spring Height. Who Is Right?

Answer»

Technician A is a correct. A CLOSED coil END of a valve spring should go against the cylinder head. Technician B is wrong because all valve SPRINGS do not use SHIMS to control assembled height. It is also wrong because it should STATE assembled height.

Technician A is a correct. A closed coil end of a valve spring should go against the cylinder head. Technician B is wrong because all valve springs do not use shims to control assembled height. It is also wrong because it should state assembled height.

Discussion

No Comment Found

Related InterviewSolutions

A Tight Timing Belt Makes What Type Of Noise?
Two Technicians Are Explaining Radiator Cap Service. Technician A Says A Radiator Cap Is Tested Using A Cooling System Pressure Tester. Technician B Says When The Radiator Cap Does Not Hold Enough Pressure, You Can Replace The Cap Gasket. Who Is Right?
A Vehicle With An Electronically Controlled Automatic Transmission Is Being Road Tested For Poor Shifting. What Should Be Done Before Doing A Road Test?
Technician A Says The Auxiliary Automatic Transmission Oil Cooler Is A Small Radiator Separate From The Engine Radiator. Technician B Says That If The Automatic Transmission Oil Cooler Lines Are Found To Be Leaking, They Are First Tightened To Specifications. Who Is Right?
A Rwd (rear Wheel Drive) Transmission Has A Leaking Output Shaft Seal On A Vehicle With 25,000 Miles On The Odometer. The Most Likely Cause For The Leakage Is:
When Replacing A Cv (constant Velocity) Joint Or Boot, What Is The Last Step Before Clamping The Boot?
Close Visual Inspection Of The Power Steering Serpentine Belt Can Reveal All Except?
Steering Dampers Can Be Used To Reduce Excessive __________?
A Technician Is Rotating The Tires Using The Modified X-method Of Tire Rotation On A Front-wheel-drive Vehicle. Where Should Be The Right Front Wheel Placed?
A Spongy Brake Pedal May Be Caused By?