What Are The Steps Required To Design A Vapor-liquid Separator Or Fla

1.	What Are The Steps Required To Design A Vapor-liquid Separator Or Flash Drum?
Answer» The STEPS that are required are as FOLLOWS: The size of the vapor-liquid separator DEPENDS on the flow rate of vapor and the liquid that is coming out of the vessel. Assumed from the flow rates that if they are known then the size can be found out. Use vertical pressure vessel to set it up or install it at given location. The length to diameter ratio will be taken to provide liquid INVENTORY between the level of liquid and the bottom of the vessel. Provide a BLOCKAGE mesh section at the vapor outlet to let the vapor pass through the mesh that is taken and can successfully leave the vessel. Let liquid flow control the level of the valve. The steps that are required are as follows:

What Are The Steps Required To Design A Vapor-liquid Separator Or Flash Drum?

Answer»

The STEPS that are required are as FOLLOWS:

The size of the vapor-liquid separator DEPENDS on the flow rate of vapor and the liquid that is coming out of the vessel.
Assumed from the flow rates that if they are known then the size can be found out.
Use vertical pressure vessel to set it up or install it at given location.
The length to diameter ratio will be taken to provide liquid INVENTORY between the level of liquid and the bottom of the vessel.
Provide a BLOCKAGE mesh section at the vapor outlet to let the vapor pass through the mesh that is taken and can successfully leave the vessel.
Let liquid flow control the level of the valve.

The steps that are required are as follows: