When a capacitor is connected to the terminals of an ohmmeter, the poi – InterviewSolution

InterviewSolution

1.	When a capacitor is connected to the terminals of an ohmmeter, the pointer indicated a low resistance initially and finally come to infinity position. This shows that capacitor is
Answer» Capacitor behaves as short circut initially and open circuit finally when fed by dc supply.

Discussion

No Comment Found

Related InterviewSolutions

A 1 mA meter is to be converted to 1 A ammeter. The meter resistance is 100 &ohm;. The value of shunt resistance is
The use of thermocouple meters for ac measurement leads to a scale which is
The current in a circuit is measured using a 150 : 1 CT If the ammeter reads 0.6 A, the circuit current is
A volt ratio box should have low resistance.
A Hall effect transducer has K = - 1 x 10. If B = 1 Wb/m, I = 3 A and bismuth slab is 2 mm wide, the Hall voltage is
Two ammeters A and B both 0-10 A have internal resistance of 1 &ohm; and 0.5 &ohm; respectively. They are connected in parallel. If total current is 15 A, then
A meter having 0-1000 μA range and 1000 &ohm; resistance is required to be changed to 0-100 mA meter. The value of shunt resistance is about
An induction wattmeter can be used for
In the balanced bridge shown in figure. should be
If the current in a capacitor leads the voltage by 80°, the loss angle of capacitor is