Which Model Is Generally Used For Transmission Lines? – InterviewSolution

1.

Which Model Is Generally Used For Transmission Lines?

Answer»

distributed ELEMENT MODEL is GENERALLY used for TRANSMISSION lines.

distributed element model is generally used for transmission lines.

Discussion

No Comment Found

Related InterviewSolutions

Which Of The Following Statements Can Be Made Concerning A Xnor (b Xnor C) = (a Xnor B) Xnor C ?
Dithering Of An Audiofrequency Signal Typically Occurs At What Stage?
In A High-pass Filter Consisting Of A Resistor And An Inductor, How Will The Cut-off Frequency Change If The Inductance Is Increased?
Why Does An "l Pad" Impedance-matching Network Bear That Name?
The Self-induced Back Voltage In A Circuit That Occurs When An Inductive Dc Circuit Is Opened May Be Safely Routed Away From The Switch With A Diode Connected Across The Inductor And Against The Dc Voltage. What Is The Main Disadvantage Of This Practice?
What Is The Characteristic Feature Of Heterodyne Processing Compared With Homodyne Processing?
On A Printed Circuit Board, What Is A Flux Capacitor?
On A Printed Circuit Board That Supports Several Different Inductors In Different Circuits, Are There Any Constraints To The Layout Of The Inductors?
One 50-ohm Resistor And Two Parallel 100-ohm Resistors Have The Same Impedance. In Which System Do The Resistors Have Lower Current When Dissipating 1 Kw?
In A Differentiator Circuit, The Output Is Approximately?