Related InterviewSolutions

• Position Of Oblong Tablets To Be Placed In Hardness Tester To Determine The Hardness? Lengthwise / Widthwise?
• Why Do We Consider Three Consecutive Runs/batches For Process Validation? Why Not Two Or Four?
• Why Do We Calibrate A Qualified Equipment/instrument On Definite Intervals?
• What Is The Difference Between Disintegration And Dissolution?
• What Is In Process Checks?
• What Is The Difference Between Calibration And Validation?
• What Checks Shall Be Carried Out, While Calibrating Dt Apparatus?
• If Sticking Observed During Tablet Compression What May The Probable Reason For The Same?
• In A Tablet Manufacturing Facility ‘positive’ Pressure Is Maintained In Processing Area Or Service Corridors?
• What Precautions Shall Be Taken While Collecting Inprocess Samples ?