1.

You want to enable both arpa and snap encapsulation on one router interface. How do you do this?(a) The interface can handle multiple encapsulation types with no extra configuration(b) Assign two network numbers, one for each encapsulation type(c) Enable Novell-ether to run multiple encapsulation types(d) Both arpa and snap are enabled by default so you don’t have to configure anythingThis question was posed to me in homework.My question is based upon IP Routing in division Networking of Computer Network

Answer»

The correct choice is (b) Assign two NETWORK numbers, one for each encapsulation type

The best explanation: To assign multiple network numbers, you USUALLY use sub interfaces. A SAMPLE CONFIGURATION follows: IPXEthernet 0.1 IPX encapsulation novell-ether ipx network 9e interface ethernet 0.2 ipx encapsulation sap ipx network 6C



Discussion

No Comment Found

Related InterviewSolutions