A large scale bearing capacity test on a footing of size 1.05 m × 1.05 m at a depth of 1.5 m yielded an ultimate value of 141 kN. Unconfined compression tests on the soft saturated clay yielded strength of 0.33 N/mm2. If the unit weight of the soil is 1.6 g/cc, how much does the test value differ from that obtained using Terzaghi's bearing capacity equation?6.804

A large scale bearing capacity test on a footing of size 1.05 m × 1.0

1.	A large scale bearing capacity test on a footing of size 1.05 m × 1.05 m at a depth of 1.5 m yielded an ultimate value of 141 kN. Unconfined compression tests on the soft saturated clay yielded strength of 0.33 N/mm2. If the unit weight of the soil is 1.6 g/cc, how much does the test value differ from that obtained using Terzaghi's bearing capacity equation?6.804
Answer» A large scale bearing capacity test on a footing of size 1.05 m $\times$ 1.05 m at a depth of 1.5 m yielded an ultimate value of 141 kN. Unconfined compression tests on the soft saturated clay yielded strength of 0.33 N/ $m m^{2}$ . If the unit weight of the soil is 1.6 g/cc, how much does the test value differ from that obtained using Terzaghi's bearing capacity equation? 6.804

Discussion

No Comment Found

Related InterviewSolutions

A timber pile of length 8m and diameter of 0.2m is driven with a 20 kN drop hammer, falling freely from a height of 1.5m. The total penetration of the Pile in the last 5 blows is 40mm. Use the engineering news record expression. Assume a factor of safety of 6 and empirical factor (allowing reducing in the theoretical set, due to energy losses) of 2.5 cm. The safe load carrying capacity Of the pile (in kN, round off to 2 decimal places) is151.515
If σh,σv,σ′handσ′v represent the total horizontal stress, total vertical stress, effective horizontal stress and effective vertical stress on a soil element, respectively. The coefficient of earth pressure at rest is given by
What is the intensity of active earth pressure at a depth of 10.0 m in dry sand with an angle of shearing resistance of 30∘ and unit weight of 18 kN/m3?
An earthen dam of height H is made of cohesive soilwhose cohesion and unit weight are c and γrespectively.If the factor of safety against cohesion is Fc, the Taylor's stability
In the plate load test, if the break on the log-log plot between the load intensity q and settlement is not well defined, the ultimate load is taken corresponding to a settlement of:
For a vertical concentrated load acting on the surface of a semi-infinite elastic soil mass, the vertical normal stress at depth 'z' is proportional to
A raft of 6 m×9 m is founded at a depth of 3m in a cohesive soil having c=120kN/m2. The ultimate net bearing capacity of the soil using the Terzaghi's theory will be nearly
A precast concrete pile is driven with a 50 kN hammer falling through a height of 1.0 m with an efficiency of 0.6. The set value observed is 4 mm per blow and the combined temporary compression of the pile, cushion and the ground is 6 mm. As per Modified Hiley Formula, the ultimate resistance of the pile is
A plate load test was conducted by using a 60 cm square plate on the top of a sandy deposit, the ultimate bearing capacity was observed as 55 kN/m2. What will be the ultimate bearing capacity for a strip footing of 1.2 m width to be placed on the surface of the same soil?
A concentrated load of 50 kN acts on the surface of ground. The increase in vertical stress directly below the load at a depth of 4 m will be (Value of influence factor is 0.48)

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment