A river model is constructed to a horizontal scale of 1 : 1000 and a vertical scale of 1 : 100. A model discharge of 0.1 m3/s would correspond to a discharge in the prototype, of what magnitude?

A river model is constructed to a horizontal scale of 1 : 1000 and a v

1.	A river model is constructed to a horizontal scale of 1 : 1000 and a vertical scale of 1 : 100. A model discharge of 0.1 m3/s would correspond to a discharge in the prototype, of what magnitude?
Answer» A river model is constructed to a horizontal scale of 1 : 1000 and a vertical scale of 1 : 100. A model discharge of 0.1 $m^{3}$ /s would correspond to a discharge in the prototype, of what magnitude?

Discussion

No Comment Found

Related InterviewSolutions

The head over a V-notch at the end of a channel is 75 cm. If an error of 0.15 cm is possible In the measurement of the head, then the percentage error in computing the discharge is
What is the momentum thickness for the boundary layer with velocity distribution uU=yδ?
The velocity field of an incompressible flow is given byV= (a1x+a2y+a3z)i+(b1x+b2y+b3z)j+(c1x+c2y+c3z)k, where a1=2 and c3=−4. The value of b2 is______2
Two immiscible, incompressible, viscous fluids having same densities but different viscosities are contained between two infinite horizontal parallel plates, 2 m apart as shown below. The bottom plate is fixed and the upper plate moves to the right with a constant velocity of 3 m/s. With the assumptions of Newtonian fluid, steady and fully developed laminar flow with zero pressure gradient in all directions, the momentum equations simplify to d2udy2=0If the dynamic viscosity of the lower fluid μ2, is twice that of the upper fluid μ1, then the velocity at the interface (round off to two decimal places) is m/s.1
For a two-dimensional irrotational flow, the velocity potential is defined as ϕ=loge (x2+y2). Which of the following is a possible stream function, ψ, for this flow?
For accurate flow measurement in open channels, an arrangement for aeration under the nappe is necessary when the weir used is
A triangular gate with a base width of 2 m and a height of 1.5 m lies in a vertical plane. The top vertex of the gate is 1.5 m below the surface of a tank which contains oil of specific gravity 0.8. Considering the density of water and acceleration due to gravity to be 1000 kg/m3 and 9.81 m/s2 respectively, the hydrostatic force (in kN) exerted by the oil on the gate is 29.43
Consider a fully developed steady laminar flow of an incompressible fluid with viscosity μ through a circular pipe of radius R. Given that the velocity at a radial location of R/2 from the centerline of the pipe is U1, the shear stress at the wall is KμU1/R, where K is _____2.66
A circular disc of diameter d is immersed vertically in a liquid of density P. The top most point of the disc just touches the liquid surface. What is the depth of Centre of pressure ?
A particle moves along a curve whose parametric equations are: x=t3+2t, y=−3e−2t and z=2 sin (5t), where x, y and z show variations of the distance covered by the particle (in cm) with time t (in s). The magnitude of the acceleration of the particle (in cm/s2 at t=0) is 12

A river model is constructed to a horizontal scale of 1 : 1000 and a vertical scale of 1 : 100. A model discharge of 0.1 m3/s would correspond to a discharge in the prototype, of what magnitude?

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment