Can An Ahb Master Be Connected Directly To An Ahb Slave?

1.	Can An Ahb Master Be Connected Directly To An Ahb Slave?
Answer» Any slave which does not use SPLIT responses can be connected directly to an AHB master. If the slave does use SPLIT responses then a simplified VERSION of the arbiter is also required. If an AHB master is connected directly to an AHB slave it is important to ensure that the slave drives HREADY high during reset and that the select signal HSEL for the slave is TIED permanently high. Any slave which does not use SPLIT responses can be connected directly to an AHB master. If the slave does use SPLIT responses then a simplified version of the arbiter is also required. If an AHB master is connected directly to an AHB slave it is important to ensure that the slave drives HREADY high during reset and that the select signal HSEL for the slave is tied permanently high.

Answer»

Any slave which does not use SPLIT responses can be connected directly to an AHB master. If the slave does use SPLIT responses then a simplified VERSION of the arbiter is also required.

If an AHB master is connected directly to an AHB slave it is important to ensure that the slave drives HREADY high during reset and that the select signal HSEL for the slave is TIED permanently high.

Any slave which does not use SPLIT responses can be connected directly to an AHB master. If the slave does use SPLIT responses then a simplified version of the arbiter is also required.

If an AHB master is connected directly to an AHB slave it is important to ensure that the slave drives HREADY high during reset and that the select signal HSEL for the slave is tied permanently high.

Discussion

No Comment Found

Related InterviewSolutions

What Is The Difference Between Split And Retry Responses?
Can A Slave Use Both Split And Retry Responses?
Do All Slaves Have To Support The Split And Retry Responses?
Can A Slave Assert Hsplitx In The Same Cycle That It Gives A Split Response?
Will A Master Always Lose The Bus After A Split Response?
Can A Split Or Retry Response Be Given At Any Point During A Burst?
Do All Masters Have To Support Split And Retry?
What Address Should Be On The Bus During The Idle Cycle After A Split Or Retry?
What Value Should Be Used For Htrans When An Ahb Master Gets A Retry Response From A Slave In The Middle Of Burst?
How Should Ahb To Apb Bridges Handle Accesses That Are Not 32-bits?