How Should Ahb To Apb Bridges Handle Accesses That Are Not 32-bits?

1.	How Should Ahb To Apb Bridges Handle Accesses That Are Not 32-bits?
Answer» The bridge should simply pass the entire 32-bit data bus through the bridge. Please note that when TRANSFERS less than 32-BITS are performed to an APB slave it is important to ensure that the PERIPHERAL is located on the appropriate bits of the APB data bus. The bridge should simply pass the entire 32-bit data bus through the bridge. Please note that when transfers less than 32-bits are performed to an APB slave it is important to ensure that the peripheral is located on the appropriate bits of the APB data bus.

Answer»

The bridge should simply pass the entire 32-bit data bus through the bridge. Please note that when TRANSFERS less than 32-BITS are performed to an APB slave it is important to ensure that the PERIPHERAL is located on the appropriate bits of the APB data bus.

The bridge should simply pass the entire 32-bit data bus through the bridge. Please note that when transfers less than 32-bits are performed to an APB slave it is important to ensure that the peripheral is located on the appropriate bits of the APB data bus.

Discussion

No Comment Found

Related InterviewSolutions

What Is The Difference Between Split And Retry Responses?
Can A Slave Use Both Split And Retry Responses?
Do All Slaves Have To Support The Split And Retry Responses?
Can A Slave Assert Hsplitx In The Same Cycle That It Gives A Split Response?
Will A Master Always Lose The Bus After A Split Response?
Can A Split Or Retry Response Be Given At Any Point During A Burst?
Do All Masters Have To Support Split And Retry?
What Address Should Be On The Bus During The Idle Cycle After A Split Or Retry?
What Value Should Be Used For Htrans When An Ahb Master Gets A Retry Response From A Slave In The Middle Of Burst?
How Should Ahb To Apb Bridges Handle Accesses That Are Not 32-bits?