Yes, you can CONFIGURE more than one EIGRP autonomous system on the same router. This is typically DONE at a redistribution point where two EIGRP autonomous systems are interconnected. Individual router interfaces should only be INCLUDED within a single EIGRP autonomous system.

Cisco does not recommend running multiple EIGRP autonomous systems on the same set of interfaces on the router. If multiple EIGRP autonomous systems are used with multiple points of mutual redistribution, it can cause discrepancies in the EIGRP topology table if correct filtering is not performed at the redistribution points. If possible, Cisco recommends you configure only one EIGRP autonomous system in any single autonomous system. You can ALSO use another protocol, such as Border Gateway Protocol (BGP), in order to CONNECT the two EIGRP autonomous systems.

Yes, you can configure more than one EIGRP autonomous system on the same router. This is typically done at a redistribution point where two EIGRP autonomous systems are interconnected. Individual router interfaces should only be included within a single EIGRP autonomous system.

Cisco does not recommend running multiple EIGRP autonomous systems on the same set of interfaces on the router. If multiple EIGRP autonomous systems are used with multiple points of mutual redistribution, it can cause discrepancies in the EIGRP topology table if correct filtering is not performed at the redistribution points. If possible, Cisco recommends you configure only one EIGRP autonomous system in any single autonomous system. You can also use another protocol, such as Border Gateway Protocol (BGP), in order to connect the two EIGRP autonomous systems.