Does The Address Have To Be Aligned, Even For Idle Transfers?

1.	Does The Address Have To Be Aligned, Even For Idle Transfers?
Answer» YES. The address should be aligned according to the transfer size (HSIZE) even for IDLE transfers. This will PREVENT spurious warnings from bus monitors USED during simulation. Yes. The address should be aligned according to the transfer size (HSIZE) even for IDLE transfers. This will prevent spurious warnings from bus monitors used during simulation.

Answer»

YES. The address should be aligned according to the transfer size (HSIZE) even for IDLE transfers. This will PREVENT spurious warnings from bus monitors USED during simulation.

Yes. The address should be aligned according to the transfer size (HSIZE) even for IDLE transfers. This will prevent spurious warnings from bus monitors used during simulation.

Discussion

No Comment Found

Related InterviewSolutions

What Is The Difference Between Split And Retry Responses?
Can A Slave Use Both Split And Retry Responses?
Do All Slaves Have To Support The Split And Retry Responses?
Can A Slave Assert Hsplitx In The Same Cycle That It Gives A Split Response?
Will A Master Always Lose The Bus After A Split Response?
Can A Split Or Retry Response Be Given At Any Point During A Burst?
Do All Masters Have To Support Split And Retry?
What Address Should Be On The Bus During The Idle Cycle After A Split Or Retry?
What Value Should Be Used For Htrans When An Ahb Master Gets A Retry Response From A Slave In The Middle Of Burst?
How Should Ahb To Apb Bridges Handle Accesses That Are Not 32-bits?

Does The Address Have To Be Aligned, Even For Idle Transfers?

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment