For a reversible physisorption process,At pressure of 1 atm, fraction – InterviewSolution

InterviewSolution

1.	For a reversible physisorption process,At pressure of 1 atm, fraction of surface covered is 0.3 i.e. (Θ=0.3). If K=kakd, then calculate the value of K
Answer» For a reversible physisorption process, At pressure of $1 a t m$ , fraction of surface covered is 0.3 i.e. $(Θ = 0.3)$ . If $K = \frac{k_{a}}{k_{d}}$ , then calculate the value of $K$

Discussion

No Comment Found

Related InterviewSolutions

If this is Energy vs Dihedral angle graph of Butane, then I,II and III are respectively :
When limestone is heated, quicklime is formed according to the equation. CaCO3(s)⇌CaO(s)+CO2(g)The experiment was carried out in the temperature range 800−900oC, Equilibrium constant Kp follows the relation. log Kp=7.282−8500Twhere, T is temperature in Kelvin. At what temperature the decomposition will give CO2(g) at 1 atm?
Which of the following solutions will have the highest boiling point?
In a compound oxide ions are present in CCP. 16 th of the tetrahedral voids are occupied cation A and 13 rd of the octahedral voids are occupied by cation B. What is the formula of the compound and what are the charges on A and B respectively.
Number of equivalent(s) of HI required for a complete reaction with the above compound is/are
Which of the following reactions will not give 2-methyl-2-phenylpropane?
An aqueous solution of BaCl2 (1.28gm in 100gm of water)boils at 100.0832∘ at 1 atm. Calculate the degree of dissociation. ( Kb of water is 0.512 k/m)
50 mL of H2 gas diffuses through a small hole from a vessel in 20 min. Time taken by 40 mL of O2 gas to diffuse under similar conditions will be :
Which of the following is not isoelectronic series?
The rate constant for a reaction depends upon each of the following, EXCEPT: