How Can I Use Only One Path When A Router Has Two Equal Cost Paths?

1.	How Can I Use Only One Path When A Router Has Two Equal Cost Paths?
Answer» Configure the BANDWIDTH value on the INTERFACES to DEFAULT, and increase the delay on the backup INTERFACE so that the ROUTER does not see two equal cost paths. Configure the bandwidth value on the interfaces to default, and increase the delay on the backup interface so that the router does not see two equal cost paths.

Answer»

Configure the BANDWIDTH value on the INTERFACES to DEFAULT, and increase the delay on the backup INTERFACE so that the ROUTER does not see two equal cost paths.

Configure the bandwidth value on the interfaces to default, and increase the delay on the backup interface so that the router does not see two equal cost paths.

Discussion

No Comment Found

Related InterviewSolutions

Is It Normal That Eigrp Takes Over 30 Seconds To Converge?
From The 16:29:14.262 Poison Squashed: 10.x.x.x/24 Reverse Message, What Does Poison Squashed Mean?
What Does The %dual-5-nbrchange: Ip-eigrp(0) 100: Neighbor 10.254.0.3 (tunnel0) Is Down: Holding Time Expired Error Message Mean?
What Are The Various Load-balancing Options Available In Eigrp?
What Are The Primary Functions Of The Pdm?
How Can I Tag External Routes In Eigrp?
What Is An Offset-list, And How Is It Useful?
How Do You Redistribute An Ipv6 Default Route In Eigrp?
What Are Different Route Types In Eigrp?
How Can I Send A Default Route To The Stub Router From The Hub?

How Can I Use Only One Path When A Router Has Two Equal Cost Paths?

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment