If you using HW Config to revise a station configuration and you want to exchange a module for one with a NEW order number for example,

proceed as follows:

• USE a drag-and-drop operation to drag the module from the Hardware CATALOG window over the old module that is already placed.
• Drop the new module. To the extent possible, the new module assumes the PARAMETERS of the one that was already inserted.

This procedure is faster than exchanging modules by deleting the old module and then inserting the new one and ASSIGNING parameters to it.

You can turn this function on or off in HW Config by means of the menu command Options > Settings (“Enable Module Swapping”)

If you using HW Config to revise a station configuration and you want to exchange a module for one with a new order number for example,

proceed as follows:

This procedure is faster than exchanging modules by deleting the old module and then inserting the new one and assigning parameters to it.

You can turn this function on or off in HW Config by means of the menu command Options > Settings (“Enable Module Swapping”)