Solve : 1997 ctx computer?

1.	Solve : 1997 ctx computer?
Answer» I got pc gave to me for my daughter to use, when I start it up a GREEN light and red light come on, then red goes off. censored pc will not boot. It running windows 98 Contact your daughter and inquire on what has happened to the COMPUTER. the pc was gave to me by a friend. Friend says pc did work but loaded slow. but will not boot at all now. could it be a hardware problem? More info on make/model.......and these green /red lights.....is this an hp pc!I don't know who makes the ctx but.. here is some infO...AMD K6....MMX ENHANCED PROCESSOR..... FEW MORE..ET-CTX98-006. HOPE THIS HELPS?Will the operating system not load? It may simply need to be reinstalled. Have you got an Operating System CD-ROM?no the pc will not load. when I start pc, it lights up then floppy disk will turn a few times with no floppy in the drive + both fans remain runnig. I have windows 98 cd that says use with new pc only, but it dose nothing when I put it into it's drive?It running windows 98 ........ So explain a bit more....so it LOADS! is there any error messages Quote no the pc will not load. when I start pc, it lights up then floppy disk will turn a few times with no floppy in the drive + both fans remain runnig. I have windows 98 cd that says use with new pc only, but it dose nothing when I put it into it's drive? Does anything appear on the monitor? Do you hear any beeps? Try resetting the BIOS if you answer no to both questions To RESET the BIOS, take the following steps: 1. Power down computer 2. Take countermeasures against electro-static discharge 3. REMOVE computer casing 4. Inspect mainboard for a CMOS jump switch or CMOS battery In case of CMOS jump switch: Follow instructions provided with the mainboard manual. In case of CMOS battery: I. Remove CMOS battery for approximately 10-15 seconds. II. After 10-15 seconds, place the CMOS battery back. 5. Power on system. *Do not power on the system when CMOS jumper is set to clear_cmos* or when CMOS battery is non-present.** done tried all them test and no good...... friend said pc= computer work fine but it loaded slow when I pluged it up I had no responce?done tried all them test and no good...... friend said pc= computer work fine but it loaded slow when I pluged it up I had no responce?Try reseating the hardware. Something may have gotten loose whilst moving it.

Answer»

I got pc gave to me for my daughter to use, when I start it up a GREEN light and red light come on, then red goes off. *censored* pc will not boot. It running windows 98 Contact your daughter and inquire on what has happened to the COMPUTER.

the pc was gave to me by a friend. Friend says pc did work but loaded slow. but will not boot at all now. could it be a hardware problem? More info on make/model.......and these green /red lights.....is this an hp pc!I don't know who makes the ctx but.. here is some infO...AMD K6....MMX ENHANCED PROCESSOR..... FEW MORE..ET-CTX98-006. HOPE THIS HELPS?Will the operating system not load? It may simply need to be reinstalled.

Have you got an Operating System CD-ROM?no the pc will not load. when I start pc, it lights up then floppy disk will turn a few times with no floppy in the drive + both fans remain runnig.
I have windows 98 cd that says use with new pc only, but it dose nothing when I put it into it's drive?It running windows 98 ........

So explain a bit more....so it LOADS! is there any error messages Quote

no the pc will not load. when I start pc, it lights up then floppy disk will turn a few times with no floppy in the drive + both fans remain runnig.
I have windows 98 cd that says use with new pc only, but it dose nothing when I put it into it's drive?

Does anything appear on the monitor?

Do you hear any beeps?

Try resetting the BIOS if you answer no to both questions

To RESET the BIOS, take the following steps:

1. Power down computer
2. Take countermeasures against electro-static discharge
3. REMOVE computer casing
4. Inspect mainboard for a CMOS jump switch or CMOS battery

In case of CMOS jump switch:

Follow instructions provided with the mainboard manual.

In case of CMOS battery:

I. Remove CMOS battery for approximately 10-15 seconds.
II. After 10-15 seconds, place the CMOS battery back.

5. Power on system.

Do not power on the system when CMOS jumper is set to clear_cmos or when CMOS battery is non-present. done tried all them test and no good...... friend said pc= computer work fine but it loaded slow when I pluged it up I had no responce?done tried all them test and no good...... friend said pc= computer work fine but it loaded slow when I pluged it up I had no responce?Try reseating the hardware. Something may have gotten loose whilst moving it.

Solve : 1997 ctx computer?

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment