Hello guys, I have experience a computer error, i hope someone could explain to me and give me some solution in this problem i have experience...

The computer is always restarting, my friend ask me if i can fix it,
When i open the computer it post the Start window normally / Last known good / and in the top is / safe mode, and even if you choose any of this OPTION the computer will just restart and bring back in that screen..

i made my first MOVE, i try to repair it, using window xp cd...then after the loading of files when it going to repair, it post a blue screen..0X000000#### like that, ive lost my notes, i wrote it but i lost it...i try it 3X and it always the same error...

i made my second move, i set another harddrive from another computer hoping it will boot properly, but it show this error ("Secondary Master Harddisk S.M.A.R.T Compatible but command failed")..but my jumper setting for the drive was correct,even i connect it in cable select...

i made my third move, i thought it was a error in the operating system and i dont have any idea how to fix it but to reformat, but before that i made a backup of it, i slave in another computer and make a backups of files using acronis2009... ok then i reformat the drive C: in another computer and it goes well until its done..then after that i put it back again in its original mboard,then i boot it again but its shows again the same error ( Start window normally / Last known good / and in the top is / safe mode )and always restarting..

in the end i just put the first harddisk(Barracuda120g)the one that i have formeted in other board for him to have a server..but the first board was not fixen,and i think i fix nothing after all of that..

i hope you guys can give idea about this,




(Blue Screen)
PAGE_FAULT_IN_NONPAGED_AREA

TECH INFO
***STOP:0x00000050

and:

it post

"secondary master harddisk S.M.A.R.T. command failed"
"compatible but command failed"Where are the rest of the #'s and letters after 0x00000050 ? ?It shows;

PAGE_FAULT_IN_NONPAGED_AREA

TECH INFO..
***STOP:0x00000050

its a blue screen, it happen every time it BEGIN to reformat or to repairQuote from: patio on April 22, 2009, 07:46:10 AM

Where are the rest of the #'s and letters after 0x00000050 ? ? xxxxxxxx xxxxxxxx xxxxxxxxxx

Requested data was not in memory. An invalid system memory address was REFERENCED. Defective memory (including MAIN memory, L2 RAM cache, video RAM) or incompatible software (including remote control and antivirus software) might cause this Stop message, as may other hardware problems (e.g., incorrect SCSI termination or a flawed PCI card).