I'm not sure if anyone else on here has attempted too do this or not.  I just kind of have a few simple questions about doing this.  So
far I have I suppose what I will as the bottom of the case built, GOT a sheet of acrylic roughly that size an ROUNDED up a few parts.  Things
such as a fan, MB + CPU an Heatsink, Front Panel CONNECTORS an suppose a way to easily mount the board.  Know when I go an get too
where I need to do some of the things such as connect the Ir's which I don't have a whole lot of currently would I be able too use only
a couple?  Like three or four an they be good for like so many inches or so till it reaches the other one or if I really need a whole mess of
them.  Also, when I go to mount the acrylic if I cant run screws into four corners of it an not have it affect the display.  Some pictures please?
Send them as attachments.
Click below where is says Additional Options...)what for pic's?     I'll have too look but, I think I seen an artical about doing this some where as well in pc mag or something.