Saved Bookmarks
| 1. |
Solve : Enable " Wake-Up by PCI card"? |
|
Answer» What MS-DOS command I can write directly enable " Wake-Up by PCI card" in the BAT file??Quote from: chelsea007 on November 08, 2007, 08:20:42 PM What MS-DOS command I can write directly enable " Wake-Up by PCI card" in the BAT file??What exactly does Wake Up do. Welcome aboard... Say again?Quote from: Broni on November 08, 2007, 09:59:48 PM Welcome aboard...If it is re regist See REPLY on your email If not I just wanted to know what ' Wake-Up by PCI card ' actually doesI know, I don't understand it, either..." Wake-Up by PCI card" can be enabled or diabled in BIOS after selecting power management set up. What MS-DOS command I can write enable it in BAT file?Most NIC Manufacturers who have NIC's with this feature have software for the network adapters to be able to flash and edit the stored ROM settings. For instance 3COM has a DOS Utility that allows you to Flash or enable and disable features like PXE Boot, Wake On Lan, Show CTRL+S option at boot to allow for you to manage it without the need for the software to edit settings. If you are looking to run a BATCH to enable or disable your feature, you will likely find that your batch file wil LOOK something like below, where the 3comPCIMGT100.exe and the command switch of -WE is used for WOL ENABLE and WD for Disable. cls @echo. This will enable the WOL @echo. 3comPCIMGT100.exe -WE cls @echo. WOL has been enabled pause Your BEST BET is to find DOS support for your NIC and see if there is a utility that can run in DOS to run a program and switch as shown above. Good Luck! Dave |
|