Solve : New Custom PC Problem.?

1.	Solve : New Custom PC Problem.?
Answer» I have a PROBLEM everytime i start my new custom pc the cpu fan and the normal fan spin but only spin once then stop. The only things i have installed are the Prosessor CPU Fan Normal Fan RAM Any ideas?For a minimum test you also NEED video, keyboard and mouse connected... Some boards will shut down if even 1 of these is not detected on boot.Yea but it has a intergrated graphics card.Still needs to be connected to a monitor...along with a keyboard and mouse.Ok i tried again turning it on without a monitor and mouse and keyboard connected. . I tried removing the ram and now the fans run for longer for about 40-50 seconds longer but then they cut out. I tried readding the ram but then it goes back to to 1-4 seconds but then i readded them and still the same i dont know what the problem is helpp:)Looks like you might be having the same issue as me. I'm hoping the solution will be to buy a power adapter that allows me to plug my fan directly into the power supply. Are you saying your CPU fan STOPS also?Quote Ok i tried again turning it on without a monitor and mouse and keyboard connected. . I'm hoping this is a typo as it was suggested to try this with thes Connected... For a bench test: Monitor Keyboard Mouse CPU and fan Vid card if needed. 1 stik of RAM. Was thermal paste applied properly ? MBoard standoffs all in place ? ? 4 prong ATX power plug connected next to the CPU ? ?Tell US about the "thermal paste" and the CPU/HEATSINK interface. Did the heatsink come with thermal paste pre-installed? Was there a "protective" plastic film over it (which you remove before installation)?

Answer»

I have a PROBLEM everytime i start my new custom pc the cpu fan and the normal fan spin but only spin once then stop. The only things i have installed are the

Prosessor
CPU Fan
Normal Fan
RAM

Any ideas?For a minimum test you also NEED video, keyboard and mouse connected...
Some boards will shut down if even 1 of these is not detected on boot.Yea but it has a intergrated graphics card.Still needs to be connected to a monitor...along with a keyboard and mouse.Ok i tried again turning it on without a monitor and mouse and keyboard connected. . I tried removing the ram and now the fans run for longer for about 40-50 seconds longer but then they cut out. I tried readding the ram but then it goes back to to 1-4 seconds but then i readded them and still the same i dont know what the problem is helpp:)Looks like you might be having the same issue as me. I'm hoping the solution will be to buy a power adapter that allows me to plug my fan directly into the power supply.

Are you saying your CPU fan STOPS also?Quote

Ok i tried again turning it on without a monitor and mouse and keyboard connected. .

I'm hoping this is a typo as it was suggested to try this with thes Connected...
For a bench test:

Monitor
Keyboard
Mouse
CPU and fan
Vid card if needed.
1 stik of RAM.

Was thermal paste applied properly ?
MBoard standoffs all in place ? ?
4 prong ATX power plug connected next to the CPU ? ?Tell US about the "thermal paste" and the CPU/HEATSINK interface. Did the heatsink come with thermal paste pre-installed? Was there a "protective" plastic film over it (which you remove before installation)?

Solve : New Custom PC Problem.?

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment