Ok here goes, major issues and should have been so simple

I have the following on a PC

Onboard Radeon x200 128mb, MOTHERBOARD is a ms 7093

So got a 512 Geforce 7300 PCI-E x16 which is correct for the pc.

Plugged in PCI-E card loaded, blank screen after it says windows loading. So i assume card is ok, as it does SHOW imaes load windows etc. Bios did not have disable onbaord graphics so i went into windows and disabled the card. Turned off pc inserted PC-E Geforce card and BOOTED, blank screen still!

So i assumed it was REFRESH rates, so tried safe mode boot, safe mode does not work ! looks like it loads minimal drivers but freezes! So i take out new card try old card, guess what? you got it blank screen, probably becuase i disabled it in windows seeing as it worked before. So now i cannot get in windows with any boot options, cannot change refresh rates, cannot enable onboard card and cannot get new one to work.

So any ideas? Is there a msdos command to enable hardware? or change refresh rate? im on the verge of a FORMAT and re-install windows, but with all my stuff it would take ages to get back.

Please advise if you can help....You need to leave out the new card and reset your BIOS to
defaults.

You can do this with your motherboard jumpers,or by removing
the CMOS battery for a couple of minutes.

Do-A-Read-Here

You may need to upgrade your BIOS to use the new Graphics card
but, that is between you and God.I never recommend BIOS upgrades.