Hi, I have recently put together a new rig. I have posted my system below. When I setup my harddrives, I set the first one up with xp then once I knew it was working, I installed the other 2. I didnt format the other two I simply installed them. I also enabled sata II on the drives.

The problem I am having is that my system recognizes the drives but I only SEE 1 drive at 80gigs even though I have 3 sata drives connected.

Why dont I see the other drives? Why dont I have more storage space?



THANKS in advance for reading and answering.




LANPARTY UT nF4-D SLI/SATAII Mod :-) THNX! --> (http://www.dfi-street.com/forum/showthread.php?t=11400)
AMD Opteron 165
Enermax EG565P 535W 20+4Pin SLI V2.0 Power Supply
OCZ EB DDR PC-4000 2x1024MB Platinum Edition Dual Channel Kit
Deskstar 7K80 X3
XFX GeForce 7900GT 256MB DDR3 Extreme Edition
UltraSharp 2007WFP 20.1-inch WIDESCREEN Flat Panel LCD Monitor
Zalman7000B-Cu LED CPU Coolerwhere are u looking for the other 2 HD's? My computer? cause chances are u wont see them there.

try this....

START>CONTROL PANEL>ADMINISTRATIVE TOOLS>COMPUTER MANAGEMENT>STORAGE>DISK MANAGEMENT

u should see ur other 2 hd's unformatted there. u also can format them there too.



reeves...... If you go into disk management in the control panel .....those other 2 drives should probably be showing up as raw ......... in other words they have not been formatted .
If you format them , they will show up in My computer .......


dl65