I have a set of drivers I had installed for a LINE 6 guitar port USB device, after install the screen went black . I tried using system restore to go back prior to install but something stopped and now. IF I boot, I will get the Vista "microsoft corporation" bar on the bottom, then just a moveable cursor and black background. I am using STAT Western Digital DRIVES with the ASUS P4C 800 E Deluxe mobo.  RAID 0 configuration.  I am planming to get a new pair of drives and just use a SATA setup with new op system and NO RAID..Is there any way to install teh old drives and access the folders for the new drive?

Using the repair function of the install DVD for Vista says' Only those shown can be system restored but it shows nothing. ALSO says it is in limited diagnostic state. Almost as if those drives are not being seen.

Thanks  AL 

3gb ram, 3.6mHz P4 CPU CD-ROM and DVD RWNot saying this will work but i would go into the bios and load default drivers then reboot.
Then go back into bios reset everything if you dont know before hand take a note of the bios setting unless
you have the manual of course, then go to boot option select your first boot as cd rom
restart and load your windows disk. follow on screen instruction for the option for repair xp /vista ?
hope this helps...