I have the Canan ip4200 Printer and one of thier Flat Bed Scanners.

And with the scanner I installed the Scan Gear Toolbox.
And I also use the canan PHOTO Bass program.

Now I have my Printer and Scanner setup so that I just turn on my Printer and hit the Copy Button on the scanner and when it scanns the item it automacitly prints it out.

And it works greate.

But when I hit the Copy Button on my scanner a window comes up asking me what program do I want to scan with
Scan Gear Tool Box
Photobass

And I have to click on Scangear Toolbox and it scanns it and sends it to the printer and prints it out.

What I need help with it useto just Automaticly Pic ScanGear Toolbox to scann with and then send it to the printer.

I remember there was a way I could bring up a window and Un Check Photobass and just leave ScanGear Toolbox Checked.

And then it would just use ScanGear Tool box when I hit the Copy Button on the Scanner.

I am GOING nuts here please help SOS
ThanksDid you look in the manual?
What model scanner?n676u is my scanner

And it has no Booklet but I never looked this up anyway.

I remember it was in the Properties of Printer or ScanGear Toolbox os something.
And I am going in and out of everything and can't find it.this is the correct manual for ScanGear with that model scanner. Try chapter 6. Maybe PAGE 73 or 76. That's all I can find and I'm not FAMILIAR with that scanner or software. Maybe Scangear issues can be better answered in the software section?
Good luck.