Hi everyone,

Sorry if this has been covered before but  I am new here ...so could a kind SOUL please help me with this?

let me explain what HAPPENED,

I had to REMOVE and open my CD burner because a piece of CD label got stuck inside.

I carefully removed the CD burner, carefully opened it, carefully removed the piece of label WITHOUT touching anything. ( The computer was off and unpluged from the wall of course! )

I did not touch the lens ( the label was not stuck to the lens )

Then I carefully re- installed and re-connnected  it in my computer.

But now when I put a CD in it ( for play back or  burning ) not much happens.

I do not HEAR it spinning.

and my computer has no reaction.  and there is no message of error or anything.

Nothing happens. ( the eject works fine though )

So I went and looked at "properties" for the CD burner unit( that one is driver D )

And it says it is at location 0 (zero)

The other CD player unit ( that on is driver E ) already in my computer - which is working fine - is at location 1 ( one )

I am no expert but my guess is when I deconnected my CD burner somehow the computer changed the location to zero, and this is why it is not working.

I think it should be at location 2 ( two )  or any number but not zero.

Am I right?

And how do I change it to a different location than zero ?

Please help ?

Thank you

Ploik359 Quote

I think it should be at location 2 ( two )  or any number but not zero.

I went and looked at "properties" for the CD burner unit