State true or false. Mean-surface panel method is used in case of final design calculations to get accurate results.(a) True(b) FalseThe question was asked during a job interview.My question is taken from General Three Dimensional Flows-Panel Techniques topic in chapter Three-Dimensional Incompressible Flow of Aerodynamics

State true or false. Mean-surface panel method is used in case of fina

1.	State true or false. Mean-surface panel method is used in case of final design calculations to get accurate results.(a) True(b) FalseThe question was asked during a job interview.My question is taken from General Three Dimensional Flows-Panel Techniques topic in chapter Three-Dimensional Incompressible Flow of Aerodynamics
Answer» Correct choice is (b) False To explain I would say: Mean-surface panel METHOD PLACES the panels in the interior side of the body. This results in less accurate results and is only USED for APPROXIMATION. Thus, this method is used for preliminary design instead of final design calculations.

Discussion

No Comment Found

Related InterviewSolutions

Is vorticity transport is obtained by constructing a finite difference approximation?(a) True(b) FalseThis question was addressed to me in a national level competition.The question is from Flow over Sphere topic in section Three-Dimensional Incompressible Flow of Aerodynamics
Is flow is defined as axisymmetric flow?(a) True(b) FalseThis question was posed to me during a job interview.Question is from Three Dimensional Doublet topic in chapter Three-Dimensional Incompressible Flow of Aerodynamics
Is kutta condition is inapplicable in the case of blunt bodies?(a) False(b) TrueThe question was posed to me in an interview.The above asked question is from Three Dimensional Source topic in division Three-Dimensional Incompressible Flow of Aerodynamics
Is flow is assumed to be axisymmetric?(a) True(b) FalseI have been asked this question during an interview for a job.The doubt is from Flow over Sphere topic in portion Three-Dimensional Incompressible Flow of Aerodynamics
Is three dimensional doublet is defined as the strength of the doublet?(a) False(b) TrueI got this question in quiz.This key question is from Three Dimensional Doublet in chapter Three-Dimensional Incompressible Flow of Aerodynamics
In how many categories is the panel method grouped into?(a) 2(b) 3(c) 4(d) 6The question was asked in quiz.Query is from General Three Dimensional Flows-Panel Techniques in chapter Three-Dimensional Incompressible Flow of Aerodynamics
Is wake vortex will produce around the three dimensional flow?(a) True(b) FalseI got this question in an online quiz.My doubt stems from Three Dimensional Source in portion Three-Dimensional Incompressible Flow of Aerodynamics
Which approximations are made in case of panel method in case of subsonic problems?(a) Quadrilateral panels with constant source strength(b) Curved panels with constant source strength(c) Triangular panels with constant sink(d) Quadrilateral panels with constant sinkThis question was addressed to me in an interview.My enquiry is from General Three Dimensional Flows-Panel Techniques topic in division Three-Dimensional Incompressible Flow of Aerodynamics
Is three dimensional source method is used for simulating incompressible potential flows?(a) True(b) FalseThe question was posed to me at a job interview.Enquiry is from Three Dimensional Source topic in portion Three-Dimensional Incompressible Flow of Aerodynamics
Which of these flows can be modelled by the panel method?(a) Compressible flow(b) Rotational flow(c) Incompressible flow(d) Supersonic flowI had been asked this question in an online quiz.My question is from General Three Dimensional Flows-Panel Techniques topic in portion Three-Dimensional Incompressible Flow of Aerodynamics

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment