The range of FHR measurement due to substitution logic is between __________ bpm.(a) 20-220(b) 60-260(c) 40-240(d) 0-200I had been asked this question in unit test.My doubt stems from Measurement of Hearing topic in chapter Audiometry of Biomedical Instrumentation

The range of FHR measurement due to substitution logic is between ____

1.	The range of FHR measurement due to substitution logic is between __________ bpm.(a) 20-220(b) 60-260(c) 40-240(d) 0-200I had been asked this question in unit test.My doubt stems from Measurement of Hearing topic in chapter Audiometry of Biomedical Instrumentation
Answer» The correct choice is (C) 40-240 To explain I would say: The RANGE of FHR measurement due to substitution logic is between 40-240 bpm. The range of FHR measurement is limited to 40–240 bpm because of the substitution logic. Thereafter, the output of logic circuits go to standard heart rate computing circuits. The substitution logic requires a DELAY time to ESTABLISH a missing foetal trigger pulse. It is thus kept as 270 ms.

Discussion

No Comment Found

Related InterviewSolutions

The middle ear is exposed to atmospheric pressure only through the _______(a) eustachian tube(b) tympanic membrane(c) pinna(d) auditory nerveThe question was posed to me in quiz.My doubt is from Mechanism of Hearing in chapter Audiometry of Biomedical Instrumentation
Speech audiometry normally allows measurements to be made within the frequency range of _____(a) 300–3000 Hz(b) 30–300 Hz(c) 300–3000 KHz(d) 3–30K HzThis question was addressed to me in examination.My question is based upon Measurement of Hearing topic in section Audiometry of Biomedical Instrumentation
Decibel expresses the logarithm of the ratio between two sound _________(a) intensities(b) powers(c) pressures(d) intensities, powers and pressuresI got this question in homework.Origin of the question is Mechanism of Hearing in division Audiometry of Biomedical Instrumentation
Which threshold of hearing is measured by a pure-tone audiometer?(a) air-conduction thresholds of hearing(b) bone-conduction thresholds of hearing(c) speech reception thresholds for diagnostic purposes(d) air-conduction and bone-conduction thresholds of hearingThis question was posed to me during an internship interview.This intriguing question comes from Mechanism of Hearing topic in division Audiometry of Biomedical Instrumentation
If I1 and I2 are two intensities in watts per square centimetre, then the number of decibels with which they are related can be expressed as _________(a) N = 10 log I1/I2(b) N = 10 log I2/I1(c) N = -10 log I1/I2(d) N = log I1/I2The question was posed to me during an interview for a job.I would like to ask this question from Mechanism of Hearing topic in chapter Audiometry of Biomedical Instrumentation
The hearing threshold is an invariable fixed intensity above which sound is always heard and below which sound is never heard.(a) True(b) FalseThis question was posed to me during an online interview.This is a very interesting question from Mechanism of Hearing topic in portion Audiometry of Biomedical Instrumentation
___________ amplifier circulatory is employed to reduce the hum noise generated by the power supply in the ECG circuit.(a) low pass filters(b) high pass filters(c) band pass filters(d) notch filtersThe question was asked in an international level competition.I need to ask this question from Measurement of Hearing topic in section Audiometry of Biomedical Instrumentation
The blood is a good conductor of electricity.(a) True(b) FalseI got this question in quiz.This intriguing question comes from Measurement of Hearing in division Audiometry of Biomedical Instrumentation
What is the role of Cupraphan in haemodialysis?(a) used to check conductivity of dialyzer(b) used as membrane(c) used to check blood leakage(d) not at all usedThe question was asked in quiz.This key question is from Measurement of Hearing in portion Audiometry of Biomedical Instrumentation
What is the role of Cupraphan in haemodialysis?(a) used to check conductivity of dialyzer(b) used as membrane(c) used to check blood leakage(d) not at all usedThis question was posed to me in an interview.I need to ask this question from Measurement of Hearing in section Audiometry of Biomedical Instrumentation

The range of FHR measurement due to substitution logic is between __________ bpm.(a) 20-220(b) 60-260(c) 40-240(d) 0-200I had been asked this question in unit test.My doubt stems from Measurement of Hearing topic in chapter Audiometry of Biomedical Instrumentation

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment