What Default State Should Be Used For The Hready And Hresp Outputs Fr

1.	What Default State Should Be Used For The Hready And Hresp Outputs From A Slave?
Answer» It is recommended that the default value for HREADY is high and the default value for HRESP is OKAY. This COMBINATION ensures that the slave will respond correctly to IDLE TRANSFERS to the slave, even if the slave is in some form of power saving mode. It is recommended that the default value for HREADY is high and the default value for HRESP is OKAY. This combination ensures that the slave will respond correctly to IDLE transfers to the slave, even if the slave is in some form of power saving mode.

What Default State Should Be Used For The Hready And Hresp Outputs From A Slave?

Answer»

It is recommended that the default value for HREADY is high and the default value for HRESP is OKAY. This COMBINATION ensures that the slave will respond correctly to IDLE TRANSFERS to the slave, even if the slave is in some form of power saving mode.

It is recommended that the default value for HREADY is high and the default value for HRESP is OKAY. This combination ensures that the slave will respond correctly to IDLE transfers to the slave, even if the slave is in some form of power saving mode.

Discussion

No Comment Found

Related InterviewSolutions

What Is The Difference Between Split And Retry Responses?
Can A Slave Use Both Split And Retry Responses?
Do All Slaves Have To Support The Split And Retry Responses?
Can A Slave Assert Hsplitx In The Same Cycle That It Gives A Split Response?
Will A Master Always Lose The Bus After A Split Response?
Can A Split Or Retry Response Be Given At Any Point During A Burst?
Do All Masters Have To Support Split And Retry?
What Address Should Be On The Bus During The Idle Cycle After A Split Or Retry?
What Value Should Be Used For Htrans When An Ahb Master Gets A Retry Response From A Slave In The Middle Of Burst?
How Should Ahb To Apb Bridges Handle Accesses That Are Not 32-bits?