For a CE transistor amplifier, the aurdio signal voltage across the collector resistance of`2.0 kOmega` is 2.0 V.Suppose the current amplification factor of the transistor is 100, what should be the value of`R_(B)` in series with `V_(B B)` supply of 2.0 V if the dc base current has to be 10 times the signal current. Also calculate the dc drop across the collector resistance (Refer to Figure).

For a CE transistor amplifier, the aurdio signal voltage across the co

1.	For a CE transistor amplifier, the aurdio signal voltage across the collector resistance of`2.0 kOmega` is 2.0 V.Suppose the current amplification factor of the transistor is 100, what should be the value of`R_(B)` in series with `V_(B B)` supply of 2.0 V if the dc base current has to be 10 times the signal current. Also calculate the dc drop across the collector resistance (Refer to Figure).
Answer» The output ac voltage is2.0 V .So, the ac collector current `i_(C ) = 2.0//2000 = 1.0 mA.` The signal current through the base is , therefore given by `i_(B ) = i_(C ) //beta = 1.0 mA// 100 = 0.010 mA`. The dc base current has to be `10 xx 0.010 = 0.10 mA` From `V_(B B ) = V_(BE ) + I_(B) R_(B) R_(B) = (V_( B B) - V_(B E) )//I_(B) `. Assuming `V_(BE) = 0.6 V` . ` R_(B) = ( 2.0 - 0.6 ) //0.10 = 14kOmega `

Discussion

No Comment Found

Related InterviewSolutions

The `V-I` characteristic of a silicon diode is shown in the Fig. Calculate the resistance of the diode at (a) `I_(D) = 15 mA` and (b) `V_(D) = -10 V`. .
Region which have no free electron and holes in P-N junction isA. x-regionB. p-regionC. depletion regionD. none of these
In an n-p-n circuit transistor, the collector current is 10 mA. If 80% electrons emitted reach the collector, thenA. the emitter current will be 7.5 mAB. the emitter current will be 12.5 mAC. the base current will be 3.5 mAD. the base current will be 1.5 mA
If a change of `100 mu A` in the base current of an `n-p-n` transistor in `CE` causes a change of `10 mA` in the collector current, the `ac` current gain of the transistor isA. 50B. 100C. 200D. 150
If `alpha and beta` are the current gain in the CB and CE configurations respectively of the transistor circuit, then `(beta-alpha)/(alphabeta)=`A. zeroB. 1C. 2D. 5
In an n-p-n transistor `10^(10)` electrons enter the emitter in `10^(-6)`s. If 2% of the electrons are lost in the base, find the current transfer ratio and the current amplification factor.A. 0.02B. 7C. 33D. 4.9
The transfer characteristics of a base biased transistor has the operation regions, namely, cutoff, active region and saturation region. For using the transistor as an amplifier it has to operate in theA. active regionB. cutoff regionC. saturation regionD. cutoff and saturation
When the voltage drop across a `p.n` junction diode is increased from `0.65V` to `0.70V`, the change in the diode current is `5mA`. What is the dynamic resistance of the diode?A. `5 Omega`B. `10 Omega`C. `20 Omega`D. `25 Omega`
A potential barrier of 0.3 V exists across a p-n junction. If the depletion region is 1 `mu`m wide, what is the intensity of electric field in this region?A. `2xx10^5 V m^(-1)`B. `3xx10^5 V m^(-1)`C. `4xx10^5 V m^(-1)`D. `5xx10^5 V m^(-1)`
In Fig . `V_(0)` is the potential barrier across a p-n junction, when no battery is connected across the junction A. 1 and 3 both correspond to forward bias of junctionB. 3 corresponds to forward bias of junction and 1 corresponds to reverse bias of junctionC. 1 corresponds to forward bias and 3 corresponds to reverse bias of junction.D. 3 and 1 both correspond to reverse bias of junction.

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment