What will happen if a capacitor is connected in parallel with RE in the amplifier design which uses emitter feedback bias circuit?(a) No changes(b) Gain value increases(c) Feedback increases(d) Gain value remains the same but feedback doublesThis question was posed to me at a job interview.I'm obligated to ask this question of Emitter Feedback Bias in chapter Transistor Biasing and Thermal Stabilization of Electronic Devices & Circuits

What will happen if a capacitor is connected in parallel with RE in th

1.	What will happen if a capacitor is connected in parallel with RE in the amplifier design which uses emitter feedback bias circuit?(a) No changes(b) Gain value increases(c) Feedback increases(d) Gain value remains the same but feedback doublesThis question was posed to me at a job interview.I'm obligated to ask this question of Emitter Feedback Bias in chapter Transistor Biasing and Thermal Stabilization of Electronic Devices & Circuits
Answer» Right answer is (b) Gain value increases To EXPLAIN I would say: Since the capacitor acts as a SHORT circuit during high frequency, there will be no feedback and HENCE gain increases. All of the current will flow to GROUND through a capacitor which acts as a short circuit.

Discussion

No Comment Found

Related InterviewSolutions

The total thermal resistance of a power transistor and heat sink is 20°C/W. The ambient temperature is 25°C and (TJ)MAX=200°C. If VCE=4V, find the maximum collector current that the transistor can carry without destruction.(a) 3.67A(b) 7.56A(c) 2.19A(d) 4.16AI have been asked this question by my college professor while I was bunking the class.Asked question is from Thermal Stability in chapter Transistor Biasing and Thermal Stabilization of Electronic Devices & Circuits
Thermal runaway is_________(a) an uncontrolled positive feedback(b) a controlled positive feedback(c) an uncontrolled negative feedback(d) a controlled negative feedbackI had been asked this question in an interview for job.My doubt stems from Thermal Runaway topic in section Transistor Biasing and Thermal Stabilization of Electronic Devices & Circuits
What is the Thevenin’s resistance (RTH) in a self bias shown below?(a) R1R2/R1+R2(b) R2/R1+R2(c) R1R2/R1-R2(d) R1/R1-R2This question was posed to me in an online interview.Query is from Self-Bias in chapter Transistor Biasing and Thermal Stabilization of Electronic Devices & Circuits
The base current for a BJT remains constant at 5mA, the collector current changes from 0.2mA to 0.3 mA and beta was changed from 100 to 110, then calculate the value of S.(a) 0.01m(b) 1m(c) 100m(d) 25mI got this question in unit test.My query is from Bias Stability topic in portion Transistor Biasing and Thermal Stabilization of Electronic Devices & Circuits
For a fixed bias circuit having RC=2Kohm and VCC=60V, IB=0.25mA and S=101, find Vce.(a) 12V(b) 10V(c) 5V(d) 2.5VThe question was posed to me in a job interview.The origin of the question is Bias Stability topic in section Transistor Biasing and Thermal Stabilization of Electronic Devices & Circuits
For a Voltage divider circuit having RC=R1=R2=RE=1KΩ, if VCC=20V, find IC when Vce = VCC?(a) 1mA(b) 2mA(c) 20mA(d) 0I had been asked this question in my homework.This is a very interesting question from The Operating Point topic in division Transistor Biasing and Thermal Stabilization of Electronic Devices & Circuits
For a Fixed bias circuit having RC=2.2KΩ, RB=240Ω, VCC=12v and current amplification factor is 100 and the current flowing through the base is 20µA, the value if Collector current in saturation is_____________(a) 5.4mA(b) 3mA(c) 1mA(d) 0AThe question was posed to me in semester exam.This interesting question is from The Operating Point in chapter Transistor Biasing and Thermal Stabilization of Electronic Devices & Circuits
The thermal runway is avoided in a collector to base bias because_________(a) of its independence on β(b) of the positive feedback produced by the base resistor(c) of the negative feedback produced by the base resistor(d) of its dependence on βI got this question in exam.I would like to ask this question from Thermal Runaway in chapter Transistor Biasing and Thermal Stabilization of Electronic Devices & Circuits
Generally, the resistance of the thermistor decreases _______(a) Exponentially with an increase in temperature(b) Linearly with an increase in temperature(c) Linearly with the decrease in temperature(d) Exponentially with the decrease in temperatureI got this question in final exam.My query is from Thermistor and Sensistor Compensation topic in division Transistor Biasing and Thermal Stabilization of Electronic Devices & Circuits
The compensation technique uses __________(a) transformers(b) inductors(c) diodes(d) capacitorsThis question was addressed to me in a national level competition.The above asked question is from Thermistor and Sensistor Compensation in division Transistor Biasing and Thermal Stabilization of Electronic Devices & Circuits

Discussion

No Comment Found

Related InterviewSolutions

Reply to Comment