|
Answer» Hi hope I m ain the right forum for this query.
I am trying to set some IP ADDRESSES on some IBM DS4300 DISK controllers before adding to a network; my INSTRUCTIONS to do this is connect my laptop to the disk controllers serial port; send a break command then set IP addresses using ipconfigset commands. (I have doen this in the past before - about a year ago). My problem today is that once I have connected my laptop to the disk controller with a usb to serial command; started HYPERTERMINAL; when i press CTRL+break command it does not send break signal to hyperterminal allowing me to access the shell on the disk.
I am using BAUD settings 19200; 8 data bits; 1 stop bit; no parity; Xon/Xoff control on comm port 6
I don't have much knowledge of hyperterminal - I was just given these instructions and they have WORKED in the past. My background is Storage infrastructure; not TCP/IP or hyperterminal!
Hope someone can suggest what I am doing wrong/a solution to try!
thanks
|
