State similarities and differences between the laboratory thermometer

1.	State similarities and differences between the laboratory thermometer and the clinical thermometer.
Answer» Similarities: 1. Working principle of both the thermometer is same. 2. Both are used to measure temperature. 3. Mercury is used in both thermometers to measure temperature. 4. Both have Celsius and fahrenheit markings. 5. Both have a bulb at one end. Differences : 1. Laboratory thermometer is used to measure temperature of different objects in factories and laboratory where as clinical thermometer is used to measure the temperature of human beings only. 2. Laboratory thermometer has temperature range from -10°C to 110°C where as clinical thermometer has temperature range from 35°C to 42°C. 3. Clinical thermometer has a kink near the bulb while there is nokink in the laboratory thermometer. (Due to kink mercury does not fall down on its own in clinical thermometer.)

State similarities and differences between the laboratory thermometer and the clinical thermometer.

Answer»

Similarities:

1. Working principle of both the thermometer is same.

2. Both are used to measure temperature.

3. Mercury is used in both thermometers to measure temperature.

4. Both have Celsius and fahrenheit markings.

5. Both have a bulb at one end.

Differences :

1. Laboratory thermometer is used to measure temperature of different objects in factories and laboratory where as clinical thermometer is used to measure the temperature of human beings only.

2. Laboratory thermometer has temperature range from -10°C to 110°C where as clinical thermometer has temperature range from 35°C to 42°C.

3. Clinical thermometer has a kink near the bulb while there is nokink in the laboratory thermometer. (Due to kink mercury does not fall down on its own in clinical thermometer.)

Discussion

No Comment Found

Related InterviewSolutions

Why are heaters fitted near the floor and air conditioners near the ceiling of a room?
Why are the Upper layers of water in a pond or a lake hotter than the lower layers during the hot summer?
In the arrangements A and B shown in Figure 4.7, pins P and Q are fixed to a metal loop and an iron rod with the help of wax. In which case are both the pins likely to fall at different times? Explain.
The heat energy required to raise the temperature of 20 kg of water from 25° C to 75° C. A) 103 cal B) 104 cal C) 105 cal D) 106 cal
Collect specific heats of various substances.
Calculate the two specific heats of nitrogen from the following data : `gamma = c_(p)//c_(v) = 1.51` density of nitrogen at N.T.P `= 1.234 g litre ^(-1)` and `J = 4.2 xx 10^(7) erg cal^(-1)`.
Calculate difference in specific heats for `1` gram of air at `N.T.P`. Given density of air at N.T.P. is `1.293 g litre^(-1), j=4.2xx10^(7)" erg "cal^(-1)`.
A vessel contains ice and is in thermal equilibrium at `-10^(@)C` and is supplied heat energy at the rate of 20 cal `s^(-1)` for 450 seconds. If the mass of ice is 0.1 kg and due to supply of heat energy, the whole ice just melts find the water equivalent of the vessel. (Take specific heat of ice `=0.5 cal g^(-1)""^(@)C^(-1)` and specific heat of the vessel is `=0.1 cal g^(-1)""^(@)C^(-1)`. Latent heat of fussion = `80 cal g^(-1)` and assume that no heat is transferred to the surroundings)
if specific heat capacity of mercury is 0.033 cal `g^(-1)" ".^(@)C^(-1)`, how much heat is gained by 0.05 kg of mercury when its temperature rises from `68^(@)F` to 313K?
Calculate the specific heat capacity at constant volume for a gas. Given specific heat capacity at constant pressure is `6.85 cal mol^(-1) K^(-1), R = 8.31 J mol^(-1)K^(-1)`. `J = 4.18 J cal^(-1)`.