Why are heaters fitted near the floor and air conditioners near the ce

1.	Why are heaters fitted near the floor and air conditioners near the ceiling of a room?
Answer» 1. Due to air conditioners, air becomes cool so its density increases and it becomes heavy. So it goes down and warm air with less density comes up and take the place of cold air. This cycle goes on and on and the whole room becomes cool. 2. If it is fitted near the floor then cool air of high density can’t go up and upper air with low density cannot come down and cooling of the room does not take place properly so air conditioners are fitted near the ceiling of a room. 3. Heaters are fitted near the floor. Due to heating, air becomes hot which is lighter than cold air. So it goes up and upper air with high density comes down. 4. This cycle goes on and on and the full room becomes warm. So heaters are fitted near the floor.

Why are heaters fitted near the floor and air conditioners near the ceiling of a room?

Answer»

1. Due to air conditioners, air becomes cool so its density increases and it becomes heavy. So it goes down and warm air with less density comes up and take the place of cold air. This cycle goes on and on and the whole room becomes cool.

2. If it is fitted near the floor then cool air of high density can’t go up and upper air with low density cannot come down and cooling of the room does not take place properly so air conditioners are fitted near the ceiling of a room.

3. Heaters are fitted near the floor. Due to heating, air becomes hot which is lighter than cold air. So it goes up and upper air with high density comes down.

4. This cycle goes on and on and the full room becomes warm. So heaters are fitted near the floor.

Discussion

No Comment Found

Related InterviewSolutions

Why are heaters fitted near the floor and air conditioners near the ceiling of a room?
Why are the Upper layers of water in a pond or a lake hotter than the lower layers during the hot summer?
In the arrangements A and B shown in Figure 4.7, pins P and Q are fixed to a metal loop and an iron rod with the help of wax. In which case are both the pins likely to fall at different times? Explain.
The heat energy required to raise the temperature of 20 kg of water from 25° C to 75° C. A) 103 cal B) 104 cal C) 105 cal D) 106 cal
Collect specific heats of various substances.
Calculate the two specific heats of nitrogen from the following data : `gamma = c_(p)//c_(v) = 1.51` density of nitrogen at N.T.P `= 1.234 g litre ^(-1)` and `J = 4.2 xx 10^(7) erg cal^(-1)`.
Calculate difference in specific heats for `1` gram of air at `N.T.P`. Given density of air at N.T.P. is `1.293 g litre^(-1), j=4.2xx10^(7)" erg "cal^(-1)`.
A vessel contains ice and is in thermal equilibrium at `-10^(@)C` and is supplied heat energy at the rate of 20 cal `s^(-1)` for 450 seconds. If the mass of ice is 0.1 kg and due to supply of heat energy, the whole ice just melts find the water equivalent of the vessel. (Take specific heat of ice `=0.5 cal g^(-1)""^(@)C^(-1)` and specific heat of the vessel is `=0.1 cal g^(-1)""^(@)C^(-1)`. Latent heat of fussion = `80 cal g^(-1)` and assume that no heat is transferred to the surroundings)
if specific heat capacity of mercury is 0.033 cal `g^(-1)" ".^(@)C^(-1)`, how much heat is gained by 0.05 kg of mercury when its temperature rises from `68^(@)F` to 313K?
Calculate the specific heat capacity at constant volume for a gas. Given specific heat capacity at constant pressure is `6.85 cal mol^(-1) K^(-1), R = 8.31 J mol^(-1)K^(-1)`. `J = 4.18 J cal^(-1)`.