The corporate office sends you a new router to connect, but upon conne – InterviewSolution

InterviewSolution

1.	The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
Answer» Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.

Discussion

No Comment Found

Related InterviewSolutions

What information is displayed by the command?
You are unsuccessful in telnetting into a remote device. What could the problem be?
Which three commands can be used to check LAN connectivity problems on a router?
Which command displays the configuration register setting?
What should the configuration register value be after you successfully complete the password recovery procedure and return the router to normal operation?
You telnet into a remote device and type , but no output from the command is seen. What could the problem be?
What does the command provide?
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
Which command will copy the IOS to a backup host on your network?
Which command loads a new version of the Cisco IOS into a router?