You telnet into a remote device and type , but no output from the com – InterviewSolution

InterviewSolution

1.	You telnet into a remote device and type , but no output from the command is seen. What could the problem be?
Answer» To see console messages through your Telnet session, you must enter the terminal monitor command.

Discussion

No Comment Found

Related InterviewSolutions

What information is displayed by the command?
You are unsuccessful in telnetting into a remote device. What could the problem be?
Which three commands can be used to check LAN connectivity problems on a router?
Which command displays the configuration register setting?
What should the configuration register value be after you successfully complete the password recovery procedure and return the router to normal operation?
You telnet into a remote device and type , but no output from the command is seen. What could the problem be?
What does the command provide?
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
Which command will copy the IOS to a backup host on your network?
Which command loads a new version of the Cisco IOS into a router?