When a router is connected to a Frame Relay WAN link using a serial DT – InterviewSolution

InterviewSolution

1.	When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?
Answer» Clocking on a serial interface is always provided by the CSU/DSU (DCE device). However, if you do not have a CSU/DSU in your nonproduction test environment, then you need to supply clocking with the clock rate command on the serial interface of the router with the DCE cable attached.

Discussion

No Comment Found

Related InterviewSolutions

Which command will display the CHAP authentication process as it occurs between two routers in the network?
How should a router that is being used in a Frame Relay network be configured to keep split horizon issues from preventing routing updates?
Which encapsulations can be configured on a serial interface?
When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational?
A default Frame Relay WAN is classified as what type of physical network?
Which WAN encapsulations can be configured on an asynchronous serial connection?