Which command displays RIP routing updates? – InterviewSolution

InterviewSolution

1.	Which command displays RIP routing updates?
Answer» The debug ip rip command is used to show the Internet Protocol (IP) Routing Information Protocol (RIP) updates being sent and received on the router.

Discussion

No Comment Found

Related InterviewSolutions

You type on your router console and see that 172.16.10.0 is being advertised to you with a metric of 16. What does this mean?
The Corporate router receives an IP packet with a source IP address of 192.168.214.20 and a destination address of 192.168.22.3. Looking at the output from the Corporate router, what will the router do with this packet?
If your routing table has a static, a RIP, and an IGRP route to the same network, which route will be used to route packets by default?
What command is used to stop RIP routing updates from exiting out an interface but still allow the interface to receive RIP route updates?
Two connected routers are configured with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?
Which command displays RIP routing updates?
Which statement is true regarding classless routing protocols?
What is split horizon?
What is route poisoning?
A network administrator views the output from the command. A network that is advertised by both RIP and IGRP appears in the routing table flagged as an IGRP route. Why is the RIP route to this network not used in the routing table?