Which command will show you whether a DTE or a DCE cable is plugged in – InterviewSolution

InterviewSolution

1.	Which command will show you whether a DTE or a DCE cable is plugged into serial 0?
Answer» The show controllers serial 0 command will show you whether either a DTE or DCE cable is connected to the interface. If it is a DCE connection, you need to add clocking with the clock rate command.

Discussion

No Comment Found

Related InterviewSolutions

What command do you type to save the configuration stored in RAM to NVRAM?
You type and receive an error. Why did you receive this message?
If you wanted administrators to see a message when logging into the router, which command would you use?
How many simultaneous Telnet sessions does a Cisco router support by default?
You set the console password, but when you display the configuration, the password doesn't show up; it looks like this: What cause the password to be stored like this?
Which command will show you whether a DTE or a DCE cable is plugged into serial 0?
You want to totally reinitialize the router and replace the current running-config with the current startup-config. What command will you use?
If you delete the contents of NVRAM and reboot the router, what mode will you be in?
You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?
Which command will delete the contents of NVRAM on a router?