You need to allow one host to be permitted to attach dynamically to ea – InterviewSolution

InterviewSolution

1.	You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
Answer» The switchport port-security is an important command, and it's super easy with the CNA; however, from the CLI, you can set the maximum number of MAC addresses allowed into the port, and then set the penalty if this maximum has been passed.

Discussion

No Comment Found

Related InterviewSolutions

You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
What command will display the forward/filter table?
If a switch receives a frame and the source MAC address is not in the MAC address table but the destination address is, what will the switch do with the frame?
What is the result of segmenting a network with a bridge (switch)?
Your switch has a port status LED that is alternating between green and amber. What could this indicate?
What are the distinct functions of layer 2 switching that increase available bandwidth on the network?
What is the purpose of Spanning Tree Protocol in a switched LAN?
Which statement describes a spanning-tree network that has converged?
What does a switch do when a frame is received on an interface and the destination hardware address is unknown or not in the filter table?
In which circumstance are multiple copies of the same unicast frame likely to be transmitted in a switched LAN?